The main drain is often a job for drain cleaning professionals to repair. If you do want to try this on your own, do so with care. The main system and lines are some of the largest but they also collect the most material around the edges of them, which leads to more frequent clogging when they are not receiving regular cleanings. It is possible to clean out and open up these systems, but to do so you will need to know a few helpful tips and methods for doing so.

The plumbing courses cover all the aspects that you will be required to deal with as a toilet. You will be taught about the basic aspects as well as about health and safety issues and sanitation.

Turn off the water to the water line repair heater or if the valve is not working turn off the water to the house. If the valve is not working it will need to be replaced. In a future article we will discuss how to replace your valve.



The first thing you need to do after leakage starts is to shut the water supply before you remove the faucet. You can either shut the valve in the sink or the main valve of your home. After that ensure that the water in the water line is drained and also the air pressure s released. This will also help in saving a lot of water that might have been wasted due to the leakage.

10) Tighten down the closet bolts making sure NOT to use too much torque. You aren't installing tires on a race car here so, take it easy Mr. Goodwrench. You just want to hold the toilet in place, not crack the porcelain base of the toilet or damage the drain flange.

Remove the cap of the faucet using slip-joint pliers. Tape the teeth of the pliers to prevent damage of the surface. Remove the faucet cam washer and water line repair the rotating ball.

Turn the water off at the main shutoff valve at the street. You should be able to take a pair of pliers(or your bare hands) and turn the valve at the water meter to shut off the water to your home. Once you have shut off the water you can cut the pipe around the leak and make the repair.

Then, you can take your new shower parts home and reinstall them in the inner assembly. It is very important that everything be aligned properly and tightened to prevent leaks. Beware of over tightening, however, since this can also cause problems. Once you are sure everything is installed properly, replace the cover plate and turn the water back on to test your repair work. With a little bit of work, your do-it-yourself shower repair project can be a success. It does not take an expert, just a little effort and know how.